描述

1794-OW8 Flex IO 繼電器輸出模塊

Allen-Bradley 1794-OW8是一個繼電器輸出模塊，是Flex I/O產品系列的一部分。該模塊主要具有八(8)個隔離常開(no . o)機電繼電器，額定250V AC, 2a, 50/60Hz電阻負載;120/240V AC, 50/60Hz,1800V A通，180V A斷;5…30V DC, 2a，電阻;

1794-OW8與1794-TB2、1794-TB3、1794-TB3S、1794-TBN和1794-TBNF端子基單元配套使用。如果使用1794-TBNF，請使用3.0安培，250VAC慢熔保險絲或Allen-Bradley推薦的保險絲。239003號。該模塊通過緩沖電路具有1.0 mA的斷態泄漏電流，最小接觸負載額定值為100 μA @ 100 mV DC。它的飛行員負荷額定值為r150,5…30V DC, 28V DC以下不超過1a。

1794-OW8兼容使用任何任何Flex I/O通信適配器以及與FlexBus控制器。該模塊電流為5V DC, 35ma，電源額定電壓為24V DC, 125ma。繼電器輸出通道在初始接觸電阻為30 mΩ時，兩個信號轉換的最大信號延遲為10 ms，開關頻率為每3秒或0.3Hz，在額定負載下，觸點平均彈跳時間為1.2 ms。此外，每個輸出觸點的預期觸點壽命為100,000次操作，最小@額定負載。

1794-OW8安裝有8個黃色狀態指示燈，每個通道1個，安裝在端子座上時按鍵開關位置為9。

1794-OW8的電源端子只使用+24伏直流電源，因?yàn)檩敵隼^電器開關時間的變化可能導致其中一個繼電器瞬間切換總負載電流。整個模塊的尺寸為1.8 x 3.7 x 2.1英寸。它兼容多種終端基礎單元，即1794-TB3、1794-TB2、1794-TBN、1794-TB3S、1794-TB3K、1794-TBNF、1794-TBNKF和1794-TB3SK。在額定負載下，它的機械壽命為10萬次。1794-OW8的電阻繼電器輸出電流額定值在5至30伏直流時為2安培，在125伏直流時為0.22安培，在125伏直流和250伏直流時為2安培。該模塊還具有250伏的連續隔離電壓，用于繼電器到另一個繼電器、背板和電源，以及50伏的電源到背板。該模塊的外部直流電源電壓范圍為直流19.2至31.2伏，包括5%的交流紋波和125 mA的標稱外部直流電源電流。在240伏交流電時，通過緩沖器的最大斷開狀態泄漏電流為1毫安。1794- ow8<e:2>的初始接觸電阻為30 M Ω，在100 mV DC下的最小接觸負載為100μA。在31.2伏直流電壓下，最大功耗為5.5瓦，最大散熱為18.8英熱單位/小時。OFF到ON和ON到OFF狀態的最大輸出延遲時間都是10毫秒。

1794-OW8 Flex IO 繼電器輸出模塊

The Allen-Bradley 1794-OW8 is a Relay output module that is part of the Flex I/O product family. This module primarily features Eight (8) isolated Normally Open (N.O.) electromechanical relay that are rated 250V AC, 2 A, 50/60Hz for resistive load; 120/240V AC, 50/60Hz,1800V A Make, 180V A Break; 5…30V DC, 2 A, Resistive;

The 1794-OW8 is used with 1794-TB2, 1794-TB3, 1794-TB3S, 1794-TBN and 1794-TBNF terminal base units. If 1794-TBNF is used, use a 3.0 Ampere, 250VAC slow-blow fuse or the Allen-Bradley recommended fuse Littelfuse with part. number 239003. This module has a off-state leakage current of 1.0 mA through snubber circuit with minimum contact load rating of 100 μA @ 100 mV DC. It has a pilot duty rating of R150, 5…30V DC, 28V A not to exceed 1 A below 28V DC.

The 1794-OW8 is compatible for use any any Flex I/O communication adapters as well as with FlexBus controllers. This module has a current draw of 5V DC, 35 mA with supply voltage rating of 24V DC, 125 mA. The relay output channels has a maximum of signal delay 10 ms for both signal transitions while the initial contact resistance is 30 mΩ, switching frequency of 1 operation every 3 s or 0.3Hz at rated load and contact mean bounce time of 1.2 ms. Additionally, each output contact has an expected contact life of 100,000 operations, min @ rated loads.

The 1794-OW8 is installed with Eight (8) yellow status indicators, One for each channel and has a keyswitch position of 9 when mounting to the terminal base.

Use only +24 Volts DC power for the 1794-OW8’s power terminals because variations in relay switching time of the outputs may cause one of the relays to momentarily switch the total load current. The entire module measures 1.8 x 3.7 x 2.1 inches. It is compatible with several terminal base units, namely the 1794-TB3, 1794-TB2, 1794-TBN, 1794-TB3S, 1794-TB3K, 1794-TBNF, 1794-TBNKF, and the 1794-TB3SK. It also has a mechanical life of 100,000 operations at rated loads. The resistive relay output current ratings of the 1794-OW8 are 2 Amps at 5 to 30 Volts DC, 0.22 Amps at 125 Volts DC, and 2 Amps for 125 Volts DC and 250 Volts DC. The module also has a continuous isolation voltage of 250 Volts for relay to another relay, to the backplane, and to the power, and 50 Volts for power to the backplane. The external DC supply voltage range of this module is 19.2 to 31.2 Volts DC and it includes the 5% AC ripple and a nominal external DC supply current of 125 mA. It has a maximum off-state leakage current of 1 mA at 240 Volts AC through a snubber. The 1794-OW8a€?s initial contact resistance is 30 M Ω and its minimum contact load is 100 μA at 100 mV DC. It also has a maximum power dissipation of 5.5 Watts and a maximum thermal dissipation of 18.8 BTU/hour, both at 31.2 Volts DC. The maximum output delay time for both the OFF to ON and the ON to OFF states are 10 milliseconds.

 

DS200DCTBG1B GE接觸器驅動板	hmv01.1.1 r – w0018 – a -07- fnn1力士樂HMV系列電源器件
if8i Allen Bradley ControlLogix模擬輸入模塊	810-082745-003 LAM plc /機器控制
8 msa3l。R0-30貝加萊伺服電機	用于交流測量的TAP-210DG/3 DEIF換能器
BINT-12C ABB接口板	FANUC驅動放大器
1769-L33ERMS艾倫布拉德利5570緊湊型GuardLogix控制器	2080-LC50-48QWB Allen Bradley Micro 850邏輯控制器
Allen-Bradley PowerFlex 753交流驅動器	2085-IF8 Allen Bradley擴展I/O模塊
橫河模擬輸入模塊	IT8000E系列-稱重端子
1756-ENT2R艾倫布拉德利以太網通信模塊	IC670ALG230 GE 8點模擬電流源輸入模塊
MPL- b430p – mk74aa Allen-Bradley Kinetix MPL低慣量伺服電機	IC670ALG330 GE 8點模擬電流源輸出模塊
MHD115C-058-PG1-BA力士樂同步電機	th300 – e1 – h ABB頭戴式溫度變送器
SCE903AN-002-01太平洋科學高性能數字伺服驅動器	MS-NAE5510-2強生MS-NAE系列網絡層控制器

 

公司介紹：
成都陽光不斷創新致力于提升停產的自動化零件供應水平，無論客戶身處何地，無論所需配件多么稀有，我們總能將客戶與所需產品緊密連接 ，成都陽光零部件覆蓋廣泛。
急切需要自動化或控制零件？ 全新、Used和已停產的自動化機械零件的全球供應商。
客戶支持快速響應
合作伙伴網絡橫跨各個大洲
全球合作伙伴網絡




Company Introduction:
Chengdu Sunshine Xihe Co., Ltd. specializes in one-stop procurement consulting for imported industrial spare parts, offering original equipment and professional discontinued parts services. We are committed to providing efficient and reliable automation solutions for our customers. Customer support fast responseThe network of partners spans all continentsGlobal partner networkAlways achieve more delivery, be it parts, service or speed



始終實現更多的交付，無論是零件、服務還是速度